Two Piece Toilet

Step 1: Ensuring Proper Measurements

Before jumping into the installation process, it's crucial to ensure that the shut-off valve is positioned at least 7 1/2" away from the center of the drain. This will allow for easy access and prevent any obstacles during the installation.

Step 2: Installing Closet Bolts

Start by installing the closet bolts to the flange channel. To do this, turn the bolts 90º and slide them into place, ensuring they are 6" apart and parallel to the wall. These bolts will provide the necessary stability for the toilet.

Step 3: Applying the Wax Ring

Place the toilet on the floor (using a cushion to prevent damage) and install the wax ring evenly around the waste flange. Make sure the tapered end of the ring is facing the toilet. This wax ring creates a watertight seal between the toilet and the drainage system.

Step 4: Positioning the Toilet on the Flange

Lower the toilet onto the closet bolts so that the bolts project through the mounting holes in the base of the toilet. Gently rock the toilet to press the bowl downward onto the wax ring and flange. Proceed to install the washer and nut in sequence.

Step 5: Installing the Toilet Tank

Place the tank gasket over the tank nut, ensuring there are no gaps between the tank and the gasket. Insert the two tank bolts into the tank mounting holes, then guide the bolts to align the tank with the bowl. Tighten the nuts alternately to stabilize them on the toilet bowl.

Step 6: Installing the Flush Button

Remove the plastic nut from the lever arm by turning it clockwise. Insert the lever arm through the square hole on the front side of the tank, and then tighten the plastic nut counterclockwise to secure it.